Okay, I'm going to attempt to clean up and organize the text you provided, correcting the repetition and formatting issues. Here's a restructured version that includes the Pin Descriptions, and the summary information at the end. I'll break it down into sections for clarity.

SY88843V

Micrel, Inc.

PIN DESCRIPTION

| Pin Number (MSOP) | Pin Number (MLF™) | Pin Name | Type | Pin Function |
|---|---|---|---|---|
| 1 | 15 | EN | TTL Input (Default High) | Enable: De-asserts true data output when low. Incorporates 25kΩ pull-up to VCC. |
| 2, 3 | 1, 4 | DIN, /DIN | Differential Data Input | Differential data input. Each pin internally terminates to REF through 50Ω. |
| 4 | 6 | REF | | Reference Voltage: Bypass with 0.01µF low ESR capacitor from REF to VCC to stabilize SDLVL and REF. |
| 5 | 14 | SDLVL | Input (Default Maximum Sensitivity) | Signal Detect Level Set: A resistor from this pin to VCC sets the threshold for the data input amplitude at which the SD output will be asserted. |
| 6 (Exposed Pad) | 2, 3, 10, 11 (Exposed Pad) | GND | Ground | Device ground. Exposed pad must be soldered (or equivalent) to the same potential as the ground pins. |
| 7 | 7 | SD | Open Collector TTL Output (Internal 4.75kΩ Pull-up Resistor) | Signal Detect: Asserts high when the data input amplitude rises above the threshold set by SDLVL. |
| 8, 9 | 9, 12 | DOUT, /DOUT | Differential CML Output | Differential data output. |
| 10 | 5, 8, 13, 16 | VCC | Power Supply | Positive power supply. Bypass with 0.1µF and 0.01µF low ESR capacitors. 0.01µF capacitors should be as close as possible to VCC pins. |

SUMMARY:

️· hbwhelp@micrel.com or (408) 955-1690

I'm not able to display tables effectively in this text-based response. The table would be properly formatted within a document or program.