Motore di ricerca datesheet componenti elettronici
  Italian  ▼
ALLDATASHEETIT.COM

X  

TSV6392AID/DT Datasheet with Chat AI
  • AIauthorized

    Hello, Please ask a question about TSV6392AID/DT Datasheet

  • # Example questions: ➢ What is the minimum input voltage (vih) required for the shdn pin to be recognized as a logic high when the supply voltage is 5v?
    ➢ What is the typical value for common mode rejection ratio (cmrr) at a supply voltage of 5v?
    ➢ How does the supply current in shutdown mode change as the ambient temperature increases from 25°c to 125°c?

  • Part No.TSV6392AID/DT
    ManufacturerSTMICROELECTRONICS
    Size942 Kbytes
    Pages25 pages
    DescriptionMIcropower (60 關A), wide bandwidth (2.4 MHz) CMOS op-amps
    Datasheet Summary with AI

    Important Notes:

    ️· Temperature: "Tmin < Top < Tmax" generally refers to the full operating temperature range, and values listed for this condition represent the *maximum* or *minimum* value across that range.
    ️· Typ: Represents the typical or nominal value, measured under specific test conditions.
    ️· Units: I'll include units with the values.
    ️· Data Variation: Data values vary significantly depending on supply voltage.

    ---

    I. Common Parameters (Across all Supply Voltages)

    ️· Input Offset Voltage (Vio):
    - TSV639x/TSV639xA: 3 mV (typical), 4.5 mV (max)
    - TSV6393AIST: 1 mV (typical), 2.2 mV (max)
    ️· Input Offset Voltage Drift (dVio): 2 µV/°C
    ️· Input Bias Current (Iib): 1 pA (typ), 100 pA (max)
    ️· Input Offset Current (Iio): 1 pA (typ), 100 pA (max)
    ️· Gain Bandwidth Product (GBP): 2.4 MHz (at 5V), 2.0 MHz (at 1.8V)
    ️· Total Harmonic Distortion + Noise (THD+N): 0.015% (5V)

    II. Electrical Characteristics by Supply Voltage

    A. Vcc = 1.8V

    ️· Common Mode Rejection Ratio (CMRR): 60 dB (typical), 55 dB (max)
    ️· Supply Voltage Rejection Ratio (SVRR): Not specified.
    ️· Large Signal Voltage Gain (Avd): 89 dB (typical), 84 dB (max)
    ️· High Level Output Voltage (VOH): 35 mV (typical), 50mV (max).
    ️· Low Level Output Voltage (VOL): Not specified.
    ️· Output Sink Current (Iout): 40 mA (typical), 65 mA (max).
    ️· Output Source Current (Iout): 40 mA (typical), 72 mA (max).
    ️· Supply Current (Icc) – No Load: 50 µA (typical), 60 µA (max).
    ️· Supply Current (Icc) – Max: 69 µA (typical), 72 µA (max).
    ️· Slew Rate (SR): 1.1 V/µs

    B. Vcc = 5V

    ️· Common Mode Rejection Ratio (CMRR): 60 dB (typical), 55 dB (max)
    ️· Supply Voltage Rejection Ratio (SVRR): 75 dB (typical), 93 dB (max).
    ️· Large Signal Voltage Gain (Avd): 89 dB (typical), 98 dB (max).
    ️· High Level Output Voltage (VOH): 35 mV (typical), 7 mV (max).
    ️· Low Level Output Voltage (VOL): 6 mV (typical), 35mV (max).
    ️· Output Sink Current (Iout): 40 mA (typical), 65 mA (max).
    ️· Output Source Current (Iout): 40 mA (typical), 72 mA (max).
    ️· Supply Current (Icc) – No Load: 50 µA (typical), 60 µA (max).
    ️· Supply Current (Icc) – Max: 60 µA (typical), 69 µA (max).
    ️· EMI Rejection Ratio (EMIRR):
    - 400 MHz: 61 dB
    - 900 MHz: 85 dB
    - 1800 MHz: 92 dB
    - 2400 MHz: 83 dB
    ️· Slew Rate (SR): 1.1 V/µs

    III. Shutdown Characteristics (Both Voltages)

    ️· Shutdown Current (Icc): 5 nA (typical), 50 nA (max)
    ️· Turn-On Time (Ton): 200 ns
    ️· Turn-Off Time (Toff): 20 ns
    ️· SHDN Logic High (VIH): 2V/5V
    ️· SHDN Logic Low (VIL): 0.8V/0.8V
    ️· Output Leakage (IOLeak): 50 pA (typical), 1 nA (max)

    ---

    Key Takeaways:

    ️· This is a relatively low-power op-amp, with quiescent currents in the microamp range.
    ️· CMRR and SVRR are good, providing rejection of common-mode and supply noise.
    ️· The op-amp is capable of driving moderate loads.
    ️· Shutdown mode is very efficient.
    ️· EMI rejection is specified for 5V supply.

    Important Notes:

    ️· Temperature: "Tmin < Top < Tmax" generally refers to the full operating temperature range, and values listed for this condition represent the *maximum* or *minimum* value across that range.
    ️· Typ: Represents the typical or nominal value, measured under specific test conditions.
    ️· Units: I'll include units with the values.
    ️· Data Variation: Data values vary significantly depending on supply voltage.

    ---

    I. Common Parameters (Across all Supply Voltages)

    ️· Input Offset Voltage (Vio):
    - TSV639x/TSV639xA: 3 mV (typical), 4.5 mV (max)
    - TSV6393AIST: 1 mV (typical), 2.2 mV (max)
    ️· Input Offset Voltage Drift (dVio): 2 µV/°C
    ️· Input Bias Current (Iib): 1 pA (typ), 100 pA (max)
    ️· Input Offset Current (Iio): 1 pA (typ), 100 pA (max)
    ️· Gain Bandwidth Product (GBP): 2.4 MHz (at 5V), 2.0 MHz (at 1.8V)
    ️· Total Harmonic Distortion + Noise (THD+N): 0.015% (5V)

    II. Electrical Characteristics by Supply Voltage

    A. Vcc = 1.8V

    ️· Common Mode Rejection Ratio (CMRR): 60 dB (typical), 55 dB (max)
    ️· Supply Voltage Rejection Ratio (SVRR): Not specified.
    ️· Large Signal Voltage Gain (Avd): 89 dB (typical), 84 dB (max)
    ️· High Level Output Voltage (VOH): 35 mV (typical), 50mV (max).
    ️· Low Level Output Voltage (VOL): Not specified.
    ️· Output Sink Current (Iout): 40 mA (typical), 65 mA (max).
    ️· Output Source Current (Iout): 40 mA (typical), 72 mA (max).
    ️· Supply Current (Icc) – No Load: 50 µA (typical), 60 µA (max).
    ️· Supply Current (Icc) – Max: 69 µA (typical), 72 µA (max).
    ️· Slew Rate (SR): 1.1 V/µs

    B. Vcc = 5V

    ️· Common Mode Rejection Ratio (CMRR): 60 dB (typical), 55 dB (max)
    ️· Supply Voltage Rejection Ratio (SVRR): 75 dB (typical), 93 dB (max).
    ️· Large Signal Voltage Gain (Avd): 89 dB (typical), 98 dB (max).
    ️· High Level Output Voltage (VOH): 35 mV (typical), 7 mV (max).
    ️· Low Level Output Voltage (VOL): 6 mV (typical), 35mV (max).
    ️· Output Sink Current (Iout): 40 mA (typical), 65 mA (max).
    ️· Output Source Current (Iout): 40 mA (typical), 72 mA (max).
    ️· Supply Current (Icc) – No Load: 50 µA (typical), 60 µA (max).
    ️· Supply Current (Icc) – Max: 60 µA (typical), 69 µA (max).
    ️· EMI Rejection Ratio (EMIRR):
    - 400 MHz: 61 dB
    - 900 MHz: 85 dB
    - 1800 MHz: 92 dB
    - 2400 MHz: 83 dB
    ️· Slew Rate (SR): 1.1 V/µs

    III. Shutdown Characteristics (Both Voltages)

    ️· Shutdown Current (Icc): 5 nA (typical), 50 nA (max)
    ️· Turn-On Time (Ton): 200 ns
    ️· Turn-Off Time (Toff): 20 ns
    ️· SHDN Logic High (VIH): 2V/5V
    ️· SHDN Logic Low (VIL): 0.8V/0.8V
    ️· Output Leakage (IOLeak): 50 pA (typical), 1 nA (max)

    ---

    Key Takeaways:

    ️· This is a relatively low-power op-amp, with quiescent currents in the microamp range.
    ️· CMRR and SVRR are good, providing rejection of common-mode and supply noise.
    ️· The op-amp is capable of driving moderate loads.
    ️· Shutdown mode is very efficient.
    ️· EMI rejection is specified for 5V supply.

    Part No.TSV6392AID/DT
    ManufacturerSTMICROELECTRONICS
    Size942 Kbytes
    Pages25 pages
    DescriptionMIcropower (60 關A), wide bandwidth (2.4 MHz) CMOS op-amps
    Lei ha avuto il aiuto da alldatasheet?  [ DONATE ] 

    Di alldatasheet   |   Richest di pubblicita   |   contatti   |   Privacy Policy   |   Collegamento alla scheda tecnica    |   scambio Link   |   Ricerca produttore
    All Rights Reserved©Alldatasheet.com


    Mirror Sites
    English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
    Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
    Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
    Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
    Family Site : ic2ic.com  |   icmetro.com