ST7263BEx datasheet(139/186 Pages) STMICROELECTRONICS

139 / 186 page

ST7263Bxx

Electrical characteristics

Doc ID 7516 Rev 8

139/186

Figure 53.

Pin input voltage

13.2

Absolute maximum ratings

Stresses above those listed as “absolute maximum ratings” may cause permanent damage

to the device. This is a stress rating only and functional operation of the device under these

conditions is not implied. Exposure to maximum rating conditions for extended periods may

affect device reliability.

Note:

Directly connecting the RESET and I/O pins to VDD or VSS could damage the device if an

unintentional internal reset is generated or an unexpected change of the I/O configuration

occurs (for example, due to a corrupted program counter). To guarantee safe operation, this

connection has to be done through a pull-up or pull-down resistor (typical: 4.7 k

Ω for

RESET, 10 k

Ω for I/Os). Unused I/O pins must be tied in the same way to V

DD or VSS

according to their reset configuration.

VIN

ST7 PIN

Table 55.

Voltage characteristics

Symbol

Ratings

Maximum value

Unit

VDD - VSS

Supply voltage

6.0

VIN

(1)(2)

Directly connecting the RESET and I/O pins to VDD or VSS could damage the device if an unintentional

internal reset is generated or an unexpected change of the I/O configuration occurs (for example, due to a

corrupted program counter). To guarantee safe operation, this connection has to be done through a pull-up

or pull-down resistor (typical: 4.7 k

Ω for RESET, 10 kΩ for I/Os). Unused I/O pins must be tied in the same

way to VDD or VSS according to their reset configuration.

IINJ(PIN) must never be exceeded. This is implicitly insured if VIN maximum is respected. If VIN maximum

cannot be respected, the injection current must be limited externally to the IINJ(PIN) value. A positive

injection is induced by VIN>VDD while a negative injection is induced by VIN<VSS. For true open-drain pads,

there is no positive injection current, and the corresponding VIN maximum must always be respected.

Input voltage on true open drain pins

VSS-0.3 to 6.0

Input voltage on any other pin

VSS-0.3 to VDD+0.3

VESD(HBM)

Electrostatic discharge voltage (Human Body

model)

Section 13.7.3

ST7263BEx Scheda tecnica(PDF) 139 Page - STMicroelectronics

ST7263BEx Scheda tecnica(HTML) 139 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Scheda tecnica Scarica

Link URL