ST10F276E datasheet(115/235 Pages) STMICROELECTRONICS

Il numero della parte	ST10F276E

Spiegazioni elettronici	16-bit MCU with MAC unit 832 Kbyte Flash memory and 68 Kbyte RAM

PDF	235 Pages

Scroll/Zoom	100%

Produttore elettronici	STMICROELECTRONICS [STMicroelectronics]

Homepage	http://www.st.com

Logo

115 / 235 page

ST10F276E

System reset

Doc ID 12303 Rev 3

115/235

5 V operation), the asynchronous reset is then immediately entered.

RSTIN pin is pulled low if bit BDRSTEN (bit 3 of SYSCON register) was previously set by software. Bit

BDRSTEN is cleared after reset.

Minimum RSTIN low pulse duration shall also be longer than 500ns to guarantee the pulse is not masked

by the internal filter (refer to Section 19.1).

Figure 29.

Synchronous short / long hardware RESET (EA = 0)

RSTIN assertion can be released there. Refer also to Section 19.1 for details on minimum pulse duration.

If during the reset condition (RSTIN low), RPD voltage drops below the threshold voltage (about 2.5V for

5V operation), the asynchronous reset is then immediately entered.

3 to 8 TCL depending on clock source selection.

RSTIN pin is pulled low if bit BDRSTEN (bit 3 of SYSCON register) was previously set by software. Bit

BDRSTEN is cleared after reset.

Minimum RSTIN low pulse duration shall also be longer than 500ns to guarantee the pulse is not masked

by the internal filter (refer to Section 19.1).

ST10F276E Scheda tecnica(PDF) 115 Page - STMicroelectronics