DOC7707 datasheet(197/307 Pages) ETC1

197 / 307 page

197

7707F–AVR–11/10

AT90USB82/162

• the UEINTX, UESTA0X and UESTA1X are restored to their reset value.

The data toggle field remains unchanged.

The other registers remain unchanged.

The endpoint configuration remains active and the endpoint is still enabled.

The endpoint reset may be associated with a clear of the data toggle command (RSTDT bit) as

an answer to the CLEAR_FEATURE USB command.

20.4

USB reset

When an USB reset is detected on the USB line (SEO state with a minimal duration of 100µs),

the next operations are performed by the controller:

• all the endpoints are disabled

• the default control endpoint remains configured

• The data toggle of the default control endpoint is cleared.

If the hardware reset function is selected, a reset is generated to the CPU core without disabling

the USB controller (that remains in the same state than after a USB Reset).

20.5

Endpoint selection

Prior to any operation performed by the CPU, the endpoint must first be selected. This is done

by setting the EPNUM2:0 bits (in UENUM register) with the endpoint number which will be man-

aged by the CPU.

The CPU can then access to the various endpoint registers and data.

20.6

Endpoint activation

The endpoint is maintained under reset as long as the EPEN bit is not set.

The following flow must be respected in order to activate an endpoint:

DOC7707 Scheda tecnica(PDF) 197 Page - List of Unclassifed Manufacturers