DOC7707 datasheet(268/307 Pages) ETC1

268 / 307 page

268

7707F–AVR–11/10

AT90USB82/162

27. AT90USB82/162 Typical Characteristics – Preliminary Data

The following charts show typical behavior. These figures are not tested during manufacturing.

All current consumption measurements are performed with all I/O pins configured as inputs and

with internal pull-ups enabled. A sine wave generator with rail-to-rail output is used as clock

source.

All Active- and Idle current consumption measurements are done with all bits in the PRR regis-

ters set and thus, the corresponding I/O modules are turned off. Also the Analog Comparator is

disabled during these measurements.

The power consumption in Power-down mode is independent of clock selection.

The current consumption is a function of several factors such as: operating voltage, operating

frequency, loading of I/O pins, switching rate of I/O pins, code executed and ambient tempera-

ture. The dominating factors are operating voltage and frequency.

The current drawn from capacitive loaded pins may be estimated (for one pin) as C

L*VCC*f where

L = load capacitance, VCC = operating voltage and f = average switching frequency of I/O pin.

The parts are characterized at frequencies higher than test limits. Parts are not guaranteed to

function properly at frequencies higher than the ordering code indicates.

The difference between current consumption in Power-down mode with Watchdog Timer

enabled and Power-down mode with Watchdog Timer disabled represents the differential cur-

rent drawn by the Watchdog Timer.

DOC7707 Scheda tecnica(PDF) 268 Page - List of Unclassifed Manufacturers