LD1085D2M33-R
AI

The **LD1085D2M33-R** is a high-performance, low-dropout (LDO) positive voltage regulator. It is designed to provide a stable 3.3V output from a higher input voltage, capable of delivering up to 3 Amperes of current.
---
### 1. Key Technical Specifications
| Parameter | Value |
| :--- | :--- |
| **Output Voltage** | 3.3 V (Fixed) |
| **Input Voltage (Max)** | 30 V |
| **Output Current** | 3 A |
| **Dropout Voltage (Typ)** | 1.3 V @ 3A |
| **Package Type** | D2PAK (TO-263) |
| **Operating Temperature** | -40°C to 125°C |
---
### 2. Internal Electronic Features
* **Low Dropout Performance:** Unlike standard linear regulators (like the L78xx series), the LD1085 can maintain regulation even when the input voltage is only ~1.3V higher than the output.
* **Built-in Protection:**
* **Current Limiting:** Protects the device during output overload or short circuits.
* **Thermal Shutdown:** Automatically shuts off the regulator if the internal junction temperature exceeds safe limits.
* **NPN Pass Transistor:** Uses an NPN output transistor to ensure stability and high current capability.
---
### 3. Application Circuit
To ensure stability, the LD1085 requires external capacitors. Below is a typical implementation:
```c
[Input Voltage (Vin)] ---+---[IN OUT]---+--- [Output 3.3V]
| [ GND ] |
[C1] | [C2]
| | |
[GND] -------------------+-------+----------+--- [GND]
// Component Values:
// C1 (Input): 10uF Tantalum or Electrolytic
// C2 (Output): 10uF to 22uF Tantalum (Required for stability)
```
---
### 4. Common Use Cases
1. **Microprocessor Power Supply:** Providing clean 3.3V power to MCUs and FPGAs.
2. **Post-Regulation:** Following a switching power supply to remove high-frequency noise.
3. **Battery Powered Equipment:** Efficiently utilizing battery voltage as it drops.
4. **High Current Logic:** Powering LED arrays or sensors requiring up to 3A.
- ⤷
What is the maximum power dissipation for the D2PAK version of this regulator?
- ⤷ How does the dropout voltage change at lower current levels?
- ⤷ Can I use ceramic capacitors for the output (C2) instead of tantalum?