Motore di ricerca datesheet componenti elettronici
  Italian  ▼
ALLDATASHEETIT.COM

X  

  • TNETE110

  • AI
    The **TNETE110**, commonly known as the **ThunderLAN™** PCI Ethernet Controller, is an integrated circuit (IC) developed by Texas Instruments. It was a pioneering single-chip solution designed to bridge the PCI bus and Ethernet networks (10Base-T and 100Base-TX). --- ### 1. Key Technical Specifications The TNETE110 integrates several complex layers of networking hardware into a single package. | Feature | Specification | | :--- | :--- | | **Interface** | PCI Local Bus Specification Revision 2.0/2.1 | | **Data Rate** | 10 Mbps (Standard) / 100 Mbps (Fast Ethernet) | | **Duplex Mode** | Full-duplex and Half-duplex support | | **FIFO Buffer** | Internal 2K-byte Transmit and 2K-byte Receive buffers | | **Media Interface** | MII (Media Independent Interface) for external PHY | | **Process Tech** | CMOS Technology | --- ### 2. Functional Blocks The architecture of the TNETE110 consists of three primary electronic subsystems: #### A. PCI Bus Interface Unit (BIU) This block handles the communication with the computer's CPU and memory. - It acts as a **PCI Master**, meaning it can initiate data transfers directly to system RAM (Direct Memory Access or DMA). - It supports 32-bit data bursts to maximize throughput and minimize CPU overhead. #### B. Media Access Control (MAC) Layer The MAC engine is responsible for the "rules" of the Ethernet protocol. - **CSMA/CD:** It handles collision detection and retransmission. - **Filtering:** It checks incoming packets for correct MAC addresses and CRC (Cyclic Redundancy Check) integrity. - **Flow Control:** It manages the pause frames to prevent buffer overflows during heavy traffic. #### C. Physical Layer (PHY) Management While the TNETE110 includes an integrated 10Base-T PHY, it often utilizes the **MII (Media Independent Interface)** to connect to external 100Base-TX transceivers. This allows the chip to be versatile across different physical media like copper or fiber. --- ### 3. Pin Configuration Categories The chip is typically housed in a **144-pin TQFP** (Thin Quad Flat Pack). The pins are categorized as follows: 1. **PCI Signals:** `AD[31:0]`, `C/BE[3:0]`, `FRAME#`, `IRDY#`, `TRDY#`, `STOP#`. 2. **Network Interface:** `TXP/TXN` (Transmit), `RXP/RXN` (Receive) for 10Mbps. 3. **MII Signals:** `MTX_CLK`, `MTXD[3:0]`, `MRX_CLK`, `MRXD[3:0]` for 100Mbps expansion. 4. **Power/Ground:** Multiple `VCC` and `GND` pins to reduce electronic noise. --- ### 4. Hardware Implementation Example To build a functional network card using the TNETE110, the following peripheral components are required: ```mermaid graph LR PCI_Slot --> TNETE110 TNETE110 --> EEPROM[93C46 EEPROM for MAC Address] TNETE110 --> Transformer[Isolation Transformer] Transformer --> RJ45[Ethernet Port] TNETE110 --> Crystal[25MHz Crystal] ```
    ✨ Follow-up Questions
    • ⤷ What are the modern replacements for the TNETE110 in current networking hardware?
    • ⤷ How does the DMA engine in the TNETE110 reduce CPU utilization?
    • ⤷ Can the TNETE110 be used in embedded systems without a PCI bus?