Features
■ Automotive Electronics Council (AEC) Q100 qualified
■ Multi-touch capacitive touchscreen and touchpad controller
   ❐ 32-bit ARM Cortex CPU
   ❐ Register configurable
   ❐ Noise suppression technologies for display and EMI
      • On-chip 10-V TX supply for higher signal-to-noise ratio (SNR)
      • External display synchronization
   ❐ Water rejection and wet finger tracking
   ❐ Large object rejection
   ❐ Automatic baseline tracking to environmental changes
   ❐ Low-power look-for-touch mode
   ❐ Field upgrades via bootloader
   ❐ Android™ driver support
   ❐ Cypress manufacturing test kit (MTK)
   ❐ Touchscreen sensor self-test and ID reporting
■ System performance
   ❐ Screen sizes up to 10.1-inch diagonal
      • 5.5-mm sensor pitch, 4:3 aspect ratio
   ❐ Up to 65 sense pins
      • 1036 intersections, 4:3 aspect ratio (37 × 28)
   ❐ Reports up to 10 fingers
   ❐ Small finger support down to 5 mm
   ❐ Large finger support up to 22 mm
   ❐ Refresh rate up to 80 Hz; other rates configurable
   ❐ Fast first-touch response ( 37.5 ms for a 10.1-inch panel)
■ Power (configuration dependent)
   ❐ 1.71-V to 5.5-V digital and I/O supply
   ❐ 2.60-V to 5.5-V analog supply
   ❐ 71-mW average power while sensing
   ❐ 45-μW typical deep-sleep power
■ Sensor and system design (configuration dependent)
   ❐ Supports a variety of touchscreen sensors and stackups
      • Manhattan and diamond patterns
      • Sensor-on-lens (SOL)
      • Plastic (PET) and glass sensor substrates
      • LCD and AMOLED displays
   ❐ Single on cell flexible printed circuit (FPC) routing enabled by flexible TX/RX configurations
■ I2C and SPI interface options
   ❐ I2C slave at all standard bit rates
      • 100 kbps, 400 kbps, 1 Mbps, and 3.4 Mbps
   ❐ SPI slave bit rates up to 8 Mbps
■ Package options
   ❐ 100-pin TQFP, 14 × 14 × 1.4 mm, 0.5-mm pin-pitch
■ Temperature ranges
   ❐ Automotive-A: –40 °C to 85 °C
   ❐ Automotive-S: –40 °C to 105 °C