General Description
DA9062 is a power management integrated circuit (PMIC) optimized for supplying systems with
single- and dual-core processors, I/O, DDR memory, and peripherals. It targets mobile devices,
medical equipment, IVI systems, and FPGA based applications.
DA9062 features four buck converters providing a total current of 8.5 A. High efficiency is achieved
over a wide load range with PFM mode available for low power or sleep modes. All power switches
are integrated, therefore, external Schottky diodes are not required. Furthermore, low-profile
inductors can be used with DA9062. Two of the buck converters can be used in a dual-phase
configuration, and one can be used as a DDR VTT supply. The four LDO regulators with
programmable output voltage provide up to 300 mA.
Dynamic voltage control (DVC) allows dynamic control of DA9062 supply voltages according to the
operating point of the system. It is controlled by writing directly to the registers using the I
2C
compatible 2-wire interface or the GPIOs.
DA9062 features a programmable power sequencer that handles start-up and shutdown sequences.
Power mode transitions can be triggered with software control, GPIOs, or with the on-key. Several
types of on-key presses can be detected to trigger different power mode transitions.
The real-time clock (RTC), with an external 32 kHz crystal oscillator, provides time keeping and alarm
functions. Additionally, the integrated watchdog timer monitors the system.
Five GPIOs are able to perform system functions, including: keypad supervision, application wakeup,
and timing-controlled external regulators/power switches or other ICs.
DA9062 is also available as an automotive AEC-Q100 Grade 2 version.

Key Features
■ Input voltage 2.8 V to 5.5 V
■ Four buck converters with dynamic voltage
control:
□ Buck1: 0.3 V to 1.57 V, 2.5 A
□ Buck2: 0.3 V to 1.57 V, 2.5 A
(can be used in dual-phase configuration
with Buck1)
□ Buck3: 0.8 V to 3.34 V, 2 A
□ Buck4: 0.53 V to 1.8 V, 1.5 A
(can be used as DDR VTT supply)
■ 3 MHz switching frequency
(enables low profile inductors)
■ Four LDO regulators:
□ LDO1: 0.9 V to 3.6 V, 100 mA
□ LDO2, LDO3, LDO4: 0.9 V to 3.6 V,
300 mA
■ Programmable power mode sequencer
■ System supply and junction temperature
monitoring
■ Watchdog timer
■ Five GPIOs
■ Coin cell/super-capacitor charger
■ Ultra-low power RTC with alarm
■ 32 kHz oscillator with external crystal
■ -40 °C to +125 °C junction temperature range
■ 40-pin QFN 6 mm × 6 mm package, 0.5 mm
pitch (exposed paddle)
■ Automotive AEC-Q100 Grade 2 version
available