Output Voltage Translation Tracks VCC
Supports Mixed-Mode Signal Operation On
All Data I/O Ports
− 5-V Input Down To 3.3-V Output Level
Shift With 3.3-V VCC
− 5-V/3.3-V Input Down To 2.5-V Output
Level Shift With 2.5-V VCC
5-V-Tolerant I/Os With Device Powered Up
or Powered Down
Bidirectional Data Flow, With Near-Zero
Propagation Delay
Low ON-State Resistance (ron)
Characteristics (ron = 5 Ω Typical)
Low Input/Output Capacitance Minimizes
Loading (Cio(OFF) = 8 pF Typical)
Data and Control Inputs Provide
Undershoot Clamp Diodes
Low Power Consumption
(ICC = 20 μA Max)
VCC Operating Range From 2.3 V to 3.6 V
Data I/Os Support 0- to 5-V Signaling
Levels (0.8 V, 1.2 V, 1.5 V, 1.8 V, 2.5 V, 3.3 V,
5 V)
Control Inputs Can Be Driven by TTL or
5-V/3.3-V CMOS Outputs
Ioff Supports Partial-Power-Down Mode
Operation
Latch-Up Performance Exceeds 250 mA Per
JESD 17
ESD Performance Tested Per JESD 22
− 2000-V Human-Body Model
(A114-B, Class II)
− 1000-V Charged-Device Model (C101)
Supports Digital Applications: Level
Translation, Memory Interleaving, Bus
Isolation
Ideal for Low-Power Portable Equipment

description/ordering information (continued)
The SN74CB3T3383 is a high-speed TTL-compatible FET bus-exchange switch with low ON-state resistance
(ron), allowing for minimal propagation delay. The device fully supports mixed-mode signal operation on all data
I/O ports by providing voltage translation that tracks VCC. The SN74CB3T3383 supports systems using 5-V
TTL, 3.3-V LVTTL, and 2.5-V CMOS switching standards, as well as user-defined switching levels
(see Figure 1).
The SN74CB3T3383 is organized as a 10-bit bus switch or as a 5-bit bus-exchange with enable (BE) input.
When used as a 5-bit bus-exchange, the device provides data exchanging between four signal ports. When BE
is low, the bus-exchange switch is ON, and the select input (BX) controls the data path. When BE is high, the
bus-exchange switch is OFF, and a high-impedance state exists between the A and B ports.
This device is fully specified for partial-power-down applications using Ioff. The Ioff feature ensures that
damaging current will not backflow through the device when it is powered down. The device has isolation during
power off.
To ensure the high-impedance state during power up or power down, BE should be tied to VCC through a pullup
resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.