1FEATURES
2• FLEXIBLE SUPPLY RANGE:
+5V to +12V Single Supply
±2.5V to ±6V Dual Supply
• WIDEBAND +5V OPERATION: 220MHz (G = 2)
• HIGH OUTPUT CURRENT: 190mA
• OUTPUT VOLTAGE SWING: ±4.0V
• HIGH SLEW RATE: 1800V/ms
• LOW SUPPLY CURRENT: 5.5mA/ch
• LOW DISABLE CURRENT: 100mA/ch

APPLICATIONS
• VIDEO LINE DRIVING
• xDSL LINE DRIVER/RECEIVER
• HIGH-SPEED IMAGING CHANNELS
• ADC BUFFERS
• PORTABLE INSTRUMENTS
• TRANSIMPEDANCE AMPLIFIERS
• ACTIVE FILTERS

DESCRIPTION
The OPA2690 represents a major step forward in
unity-gain stable, voltage-feedback op amps. A new
internal architecture provides slew rate and full-power
bandwidth previously found only in wideband,
current-feedback op amps. A new output stage
architecture delivers high currents with a minimal
headroom requirement. These give exceptional
single-supply operation. Using a single +5V supply,
the OPA2690 can deliver a 1V to 4V output swing with over 120mA drive current and 150MHz
bandwidth. This combination of features makes the
OPA2690 an ideal RGB line driver or single-supply
Analog-to-Digital Converter (ADC) input driver.
The low 5.5mA/ch supply current of the OPA2690 is
precisely trimmed at +25°C. This trim, along with low
temperature drift, provides lower maximum supply
current than competing products. System power may
be reduced further using the optional disable control pin. Leaving this disable pin open, or holding it HIGH,
will operate the OPA2690I-14D normally. If pulled
LOW, the OPA2690I-14D supply current drops to less
than 200mA/ch while the output goes to a
high-impedance state.