© 2011 Fairchild Semiconductor Corporation

www.fairchildsemi.com

FDMF6823C • Rev. 1.0.3

Pin Configuration

Figure 3.

Bottom View

Figure 4.

Top View

Pin Definitions

Pin #

Name

Description

1

SMOD#

When SMOD#=HIGH, the low-side driver is the inverse of the PWM input. When

SMOD#=LOW, the low-side driver is disabled. This pin has a 10 µA internal pull-up current

source. Do not add a noise filter capacitor.

2

VCIN

IC bias supply. Minimum 1 µF ceramic capacitor is recommended from this pin to CGND.

3

VDRV

Power for the gate driver. Minimum 1 µF ceramic capacitor is recommended to be connected

as close as possible from this pin to CGND.

4

BOOT

Bootstrap supply input. Provides voltage supply to the high-side MOSFET driver. Connect a

bootstrap capacitor from this pin to PHASE.

5, 37, 41

CGND

IC ground. Ground return for driver IC.

6

GH

For manufacturing test only. This pin must float; it must not be connected to any pin.

7

PHASE Switch node pin for bootstrap capacitor routing. Electrically shorted to VSWH pin.

8

NC

No connect. The pin is not electrically connected internally, but can be connected to VIN for

convenience.

9 - 14, 42

VIN

Power input. Output stage supply voltage.

15, 29 -

35, 43

VSWH

Switch node input. Provides return for high-side bootstrapped driver and acts as a sense point

for the adaptive shoot-through protection.

16 – 28

PGND

Power ground. Output stage ground. Source pin of the low-side MOSFET.

36

GL

For manufacturing test only. This pin must float; it must not be connected to any pin.

38

THWN#

Thermal warning flag, open collector output. When temperature exceeds the trip limit, the

output is pulled LOW. THWN# does not disable the module.

39

DISB#

Output disable. When LOW, this pin disables the power MOSFET switching (GH and GL are

held LOW). This pin has a 10 µA internal pull-down current source. Do not add a noise filter

capacitor.

40

PWM

PWM signal input. This pin accepts a three-state 5 V PWM signal from the controller.