LT3790 datasheet(14/30 Pages) LINER

14 / 30 page

LT8390A

8390afa

For more information www.linear.com/LT8390A

(3) Peak-Boost in Buck-Boost Region (VIN <~ VOUT)

When VIN is slightly lower than VOUT, the LT8390A uses

peak-boost current mode control in buck-boost region

(Figure 6). Switch A is always turned on for the begin-

ning 80% cycle and switch B is always turned on for the

remaining 20% cycle. At the beginning of every cycle,

switches A and C are turned on and the inductor current

ramps up. When the inductor current hits the peak boost

current threshold commanded by VC voltage at boost

current comparator A4 during (A+C) phase, switch C is

turned off and switch D is turned on for the rest of the

cycle. After 80% cycle, switch A is turned off and switch

B is turned on for the rest of the cycle.

OPERATION

Figure 6. Peak-Boost in Buck-Boost Region (VIN <~ VOUT)

Figure 7. Peak-Boost in Boost Region (VIN << VOUT)

20%

80%

20%

A+D

A+C

B+D

A+D

A+C

B+D

8390a F06

(4) Peak-Boost in Boost Region (VIN << VOUT)

When VIN is much lower than VOUT, the LT8390A uses

peak-boostcurrentmodecontrolinboostregion(Figure7).

Switch A is always on and switch B is always off. At the

beginning of every cycle, switch C is turned on and the

inductor current ramps up. When the inductor current hits

the peak boost current threshold commanded by VC volt-

age at boost current comparator A4 during (A+C) phase,

switch C is turned off and switch D is turned on for the

rest of the cycle. Switches C and D will alternate, behaving

like a typical synchronous boost regulator.

100% ON

100% OFF

A+D

A+C

A+D

A+C

8390a F07

LT3790 Scheda tecnica(PDF) 14 Page - Linear Technology

LT3790 Scheda tecnica(HTML) 14 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30

Scheda tecnica Scarica

Link URL