1104LS series

Soldering condition

4. If soldering manually, Stanley recommends using a soldering iron equipped with temperature control.

During the actual soldering process, make sure that the soldering iron never touch the LED itself, and

avoid the LED's electrode heating temperature reaching above the heating temperature of the solder pad.

All repairs must be performed only once in the same spot, and please avoid reusing components.

5. In soldering process, immediately after iron tip is cleaned, please make sure that the soldering iron reaches

the appropriate temperature before using. Also, please avoid applying any type of pressure to the soldered

components before the solder has been cooled and hardened, as it may deteriorate solder performance and

solder quality.

6. When using adhesive material for tentative fixatives, thermosetting resin or Ultraviolet radiation (UV)

setting resin with heat shall be recommended.

《The curing condition, Temperature:150℃Max./Time:120sec.Max.》

7. Flow soldering (dip soldering) is not recommended for this product.

8. lsopropyl alcohol is recommended for cleaning. Some chemicals, including Freon substitute detergent

could corrode the lens or the casing surface, which cause discoloration, cloud, crack and so on. Please

review the reference chart below for cleaning. If water is used to clean (including the final cleaning

process), please use pure water (not tap water), and completely dry the component before using.

【Recommended manual soldering condition】

Temperature of Iron tip

350℃MAX.

Soldering duration, Time

3sec.Max.,1 time

Cleaning agents

Recommended / Not recommended

Isopropyl alcohol

 Recommended

Trichloroethylene

x Not recommended

Chlorothene

x Not recommended

Acetone

x Not recommended

Thinner

x Not recommended

Page 8

2017.11.20