OL2385SWUG datasheet(35/64 Pages) NXP

35 / 64 page

NXP Semiconductors

OL2385SWUG

SIGFOX software driver

OL2385SWUG

All information provided in this document is subject to legal disclaimers.

User guide

Rev. 2.1 — 6 April 2018

35 / 64

Figure 23. Logging into your SIGFOX account

7.1.2 Verifying the successful transmission

After registering the device at the backend, the device can now transmit a SIGFOX

message that can be viewed on a browser.

Note: If you are not using your own leased base station from SIGFOX, you will not be

able to see the BASE STATION tab on the portal, which you can see in these sample

figures. In that case, you can only see the rest of the tabs.

1. Log into your SIGFOX account by visiting: backend.SIGFOX.com/auth/login.

2. Click on the

DEVICE tab to see all of your registered devices, as shown in Figure 24.

3. Click on the device ID of the device for which you would like to verify transmission.

4. Make sure you have the right firmware on the device. Check Section 6.1 and

Section 5.4.2 in case you have to update the device firmware.

5. Prepare the hardware connections of your device as per Section 5.4.1.2 "Connecting

the hardware for use with the SIGFOX network". Power-on your device.

6. Depending on the choice of firmware, send a SIGFOX message on radio by

performing any of the following actions

a. Send SPI command

Send payload. See Section 5.4.1 "Setting up KL43Z

board with terminal program" for sending SPI commands. If the hardware is

freshly powered on or reset, send the sequence: 1 (Send wakeup), 15/16/17/18

(Change_To_RCZX depending on the region), 4 (Send payload)

b. Or do a button press (If button press based firmware on device)

c. Or send an AT command via terminal on PC to send a SIGFOX frame (If UART

based firmware on device)

7. Click on the

Messages tab on the portal as shown in Figure 25.

8. Depending on the contract you have for your device with SIGFOX, you are able to see

certain fields for each message. This is dependent on the amount of access rights you

have for your device. For more details, contact support@SIGFOX.com. A minimum

of following fields should at least be visible: Time, Data / Decoding, Location, Link

quality, Callbacks. An example of extended fields with higher access is shown in the

figure below.

9. Similarly, the messages can be sent by the device and checked here at the portal any

number of times. Generally speaking, one can see the device message appears on

OL2385SWUG Scheda tecnica(PDF) 35 Page - NXP Semiconductors

OL2385SWUG Scheda tecnica(HTML) 35 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64

Scheda tecnica Scarica

Link URL