CM312 datasheet(41/56 Pages) ETC

41 / 56 page

CM312 Quad Serial utilityModule

RTD Embedded Technologies, Inc.

•

boot DOS from a floppy

•

run netgen and select Netware Installation

•

reboot from hard disk

To generate the 2.2 server from an existing Network Disk:

•

Boot DOS from a floppy

•

Run install (when prompted to, select NE2000 driver)

•

reboot from hard drive

Novell Netware 3.x/4.x

Use the install.nlm utility loaded from the server console, "load ...\install", to create an autoexec

file as shown below:

AUTOEXEC.NCF

file server name BIGKAHOONAS

ipx internal net 10

load c:\ne2000 PORT=360 INT=5

bind ipx to ne2000 net=1

mount all

Typing SERVER at the DOS prompt will load the server and our driver.

Be sure ne2000.lan is in the c:\ directory

Driver configurable options are:

IO BASE

May be set by including the following in the command line:

Port = xxx

;where xxx can be 300, 320, 340, 360

Be sure the board is set to the same I/O address, otherwise the driver won't find the board and the

message "Hardware Error - NE2000 Bank Select port failed to respond." will appear.

INTERRUPT NUMBER

May be set by including the following in the command line:

Int = x

;where x can be 2, 3, 4, 5, 10, 11, 12, 15

Defaults to EEPROM configuration if not present

NODE ADDRESS

The board has a unique IEEE address, but it may be overwritten by including the following in the

command line:

Node = xxxxxxxxxxxx

Where xxxxxxxxxxxx is a 12 digit hex number (non-multicast or broadcast)

CM312 Scheda tecnica(PDF) 41 Page - List of Unclassifed Manufacturers

CM312 Scheda tecnica(HTML) 41 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

Scheda tecnica Scarica

Link URL