TYPICAL CONNECTION DIAGRAM

The output voltage of the MSK 5021 can be adjusted from +1.3 volts to +36 volts. Refer to the following

formula for resistor divider selection. R2 shall be 10K

Ω for all applications.

The above connection diagram illustrates an MSK 5021 regulator. Q1 turns on the Fault L.E.D. when pin 6 of the

hybrid drops to a logic low. Current into pin 6 is limited to approximately 1mA by the 12K

Ω resistor from pin 5 to pin

10µF is a good starting point.

The ENABLE input is TTL compatible but can be tied to the input voltage when

tion note.

OUTPUT VOLTAGE ADJUSTMENT:

4

Rev. F

1/05

5