MAS6505 datasheet(8/44 Pages) MAS

8 / 44 page

DA6505.005

11 June 2018

8 (44)

FUNCTIONAL DESCRIPTION

 Power on reset

The MAS6505 has power on reset (POR) circuitry

which resets the device into standby mode after both

power supplies VDD and VDDIO have risen to

sufficient levels. The VDD is supply voltage for

analog and digital blocks and the VDDIO is supply

voltage for the digital I2C and SPI serial bus

interface. There are no limitations for the slope and

sequence of raising of the VDD and VDDIO supplies.

However it is recommended to reset the device

manually after every power up to make sure it is

reset properly. This is accomplished via serial bus by

writing

any data

byte

to the Reset register

(EC/6CHEX). See table 1 for MAS6505 memory

addresses. The POR or writing to the Reset register

will reset all registers from ED/6DHEX to FF/7FHEX to

a zero (00HEX) value.

 Digital interface selection

The MAS605 supports I2C and SPI digital interfaces.

The I2C interface is a 2-wire serial bus which is

selected by leaving the CSB pin unconnected

(floating) or by connecting it to VDDIO. The CSB pin

has internal 250 kΩ pull-up resistor to VDDIO. Note:

The 2-wire I2C bus of MAS6505 supports only basic

I2C bus communication protocol but not for example

10-bit addressing, arbitration and clock stretching

features of the I2C bus specification.

The SPI interface supports 3-wire and 4- wire serial

bus communication. Selection between 3- and 4-

wire SPI bus modes is done by WIRE bit in the

Configuration register (EE/6EHEX). See table 3. After

power up the WIRE=0 which selects the 4-wire SPI

bus mode. To select 3-wire SPI bus mode it is

necessary to first set WIRE=1 by writing to the

Configuration register.

The SPI communication is selected by pulling the

CSB pin low. It has an additional SPI mode lock in

feature. By pulling CSB low and giving at least four

SCK clock pulses makes the digital interface to lock

into SPI communication mode. This is done in order

to avoid inadvertently decoding SPI traffic to another

slave device as I2C data. After entering SPI lock

mode the I2C communication is possible only after

applying power on reset.

MAS6505 Scheda tecnica(PDF) 8 Page - Micro Analog systems

MAS6505 Scheda tecnica(HTML) 8 Page - Micro Analog systems

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Scheda tecnica Scarica

Link URL