25C320TESLASHST datasheet(10/24 Pages) MICROCHIP

10 / 24 page

25AA320/25LC320/25C320

DS21227E-page 10

 2004 Microchip Technology Inc.

3.5

Read Status Register Instruction

(RDSR)

The Read Status Register instruction (RDSR) provides

access to the Status register. The Status register may

be read at any time, even during a write cycle. The

Status register is formatted as follows:

The Write-In-Process (WIP) bit indicates whether the

25XX320 is busy with a write operation. When set to a

‘1’, a write is in progress; when set to a ‘0’, no write is

in progress. This bit is read-only.

The Write Enable Latch (WEL) bit indicates the status

of the write enable latch. When set to a ‘1’, the latch

allows writes to the array, when set to a ‘0’, the latch

prohibits writes to the array. The state of this bit can

always be updated via the WREN or WRDI commands

regardless of the state of write protection on the Status

The Block Protection (BP0 and BP1) bits indicate

which blocks are currently write-protected. These bits

are set by the user issuing the WRSR instruction. These

bits are nonvolatile.

See Figure 3-6 for the RDSR timing sequence.

FIGURE 3-6:

READ STATUS REGISTER TIMING SEQUENCE

WPEN

BP1

BP0

WEL

WIP

1011

1314

765

instruction

data from Status register

High-impedance

SCK

4567

25C320TE/ST Scheda tecnica(PDF) 10 Page - Microchip Technology