GD25LE40CNJG datasheet(43/75 Pages) GIGADEVICE

43 / 75 page

1.8V Uniform Sector

Dual and Quad Serial Flash

GD25LE40C/20C/10C/05C

Figure33. Read Security Registers command Sequence Diagram

7.32 Enable Reset (66H) and Reset (99H)

If the Reset command is accepted, any on-going internal operation will be terminated and the device will return to its default

power-on state and lose all the current volatile settings, such as Volatile Status Register bits, Write Enable Latch status

(WEL), Program/Erase Suspend status, Read Parameter setting (P7-P0), Deep Power Down Mode, Continuous Read Mode

bit setting (M7-M0) and Wrap Bit Setting (W6-W4).

The “Enable Reset (66H)” and the “Reset (99H)” commands can be issued in either SPI mode. The “Reset (99H)” command

sequence as follow: CS# goes low  Sending Enable Reset command  CS# goes high  CS# goes low  Sending

Reset command  CS# goes high. Once the Reset command is accepted by the device, the device will take approximately

tRST/tRST_E to reset. During this period, no command will be accepted. Data corruption may happen if there is an on-going or

suspended internal Erase or Program operation when Reset command sequence is accepted by the device. It is

recommended to check the BUSY bit and the SUS bit in Status Register before issuing the Reset command sequence.

Figure34. Enable Reset and Reset command Sequence Diagram

Command

66H

CS#

SCLK

High-Z

Command

99H

Command

48H

CS#

SCLK

High-Z

9 10

28 29 30 31

23 22 21

24-bit address

MSB

34 35 36 37

38 39

Data Out1

42 43 44 45

46 47

Data Out2

CS#

SCLK

MSB

Dummy Byte

GD25LE40CNJG Scheda tecnica(PDF) 43 Page - GigaDevice Semiconductor (Beijing) Inc.

GD25LE40CNJG Scheda tecnica(HTML) 43 Page - GigaDevice Semiconductor (Beijing) Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75

Scheda tecnica Scarica

Link URL