TLV9101IDBVR datasheet(29/50 Pages) TI1

29 / 50 page

Time (ms)

0.2

0.4

0.6

0.8

1.2

1.4

1.6

1.8

-2

comp

Input

Output

TLV9101, TLV9102, TLV9104

www.ti.com

SBOS943A – FEBRUARY 2019 – REVISED APRIL 2019

Product Folder Links: TLV9102

Submit Documentation Feedback

Typical Applications (continued)

8.2.1.2 Detailed Design Procedure

This noninverting comparator circuit applies the input voltage (VIN) to the noninverting terminal of the op amp.

Two resistors (R1 and R2) divide the supply voltage (V+) to create a mid-supply threshold voltage (VTH) as

calculated in Equation 1. The circuit is shown in Figure 53. When VIN is less then VTH, the output voltage

transitions to the negative supply and equals the low-level output voltage. When VIN is greater than VTH, the

output voltage transitions to the positive supply and equals the high-level output voltage.

In this example, resistor 1 and 2 have been selected to be 100 kΩ, which sets the reference threshold at 7.5 V.

However, resistor 1 and 2 can be adjusted to modify the threshold using Equation 1. Resistor 1 and 2's values

have also been selected to reduce power consumption, but these values can be further increased to reduce

power consumption, or reduced to improve noise performance.

(1)

8.2.1.3 Application Curve

Figure 54. Comparator Output Response to Input Voltage

TLV9101IDBVR Scheda tecnica(PDF) 29 Page - Texas Instruments