Factory Default Settings. The following settings are preset at the factory; revert sensor to factory defaults using

Advanced Setup procedure (see Advanced Setup on page 6)

•

Dark Operate (DO)

•

50% DES

•

Health Mode Display

•

2% Threshold Offset Percentage

•

Normal Display Orientation

•

High Speed (HS)

Sensor Programming

Programming Procedures. Use the Dynamic (+) and Static (-) buttons to access and set programming parameters. For

remote programming, connect a switch or digital input to the gray wire (remote line); the length of the individual pulses is

equal to the value T when 0.04 seconds ≤ T ≤ 0.8 seconds.

Returning to RUN mode. Exit Setup mode by stepping through the entire Setup process (see Sensor Setup on page

4), by escaping out of the Setup process, or by exceeding the 60 second inactivity time-out. To escape out of the Setup

process, press and hold both the Static (-) and Dynamic (+) buttons for 2 seconds. (For remote programming, press and

hold the remote line for 2 seconds). The sensor always saves the selected settings and returns to Run mode.

Sensor Setup

•

Configures sensor display and operating parameters.

•

Changes are updated instantly.

•

Click Dynamic (+) or double-pulse remote line to select an option.

•

Click Static (-) or single-pulse remote line to advance.

Remote input pulse: 0.04 s ≤ T ≤ 0.8 s

1. Access Setup mode.

Method

Action

Result

Push Button

Press and hold both the Dynamic (+) and

Static (-) buttons concurrently for more than 2

seconds

•

Arrow Icon 1 ON Red

•

Arrow Icon 2 OFF

•

Display shows “Threshold Offset

Percentage” option.

Remote Input

Double-pulse the remote line

2. Select the threshold offset percentage.

Method

Action

Result

Push Button

Click Dynamic (+) to toggle between selections

Click Static (-) to save selection and advance

to “Light/Dark Operate”

2% to 10% Threshold Offset Percentage:

“t 2,” “t 3,” “t 4,” “t 5,” “t 10”

Remote Input

Double-pulse remote line to toggle between

selections

Single-pulse the remote line to save selection

and advance to “Light/Dark Operate"

D10 Expert Series - Small Object Counter

4

www.bannerengineering.com - tel: 763-544-3164

P/N 146132 Rev. D