www.ti.com

Appendix B

15

SNAU228 – January 2018

Submit Documentation Feedback

Copyright © 2018, Texas Instruments Incorporated

USB2ANY Cable Connections

Table 2. 10-pin Cable Pinouts (continued)

Schematic Pin Number

Cable Pin Number

Signals Available

J4-2

9

GPIO1, I2C:SCL, OW3

J4-1

10

GPIO0, I2C:SDA, OW4

NOTE:

The pin numbers for J4 on the schematics are for reference only and do not correspond to

the pin numbers for cable connections.

The 30-pin cable is also about 6 inches in length and has a keyed female 30-pin IDC connector on each

end. This cable provides access to all available signals. The cable should be connected to the USB2ANY

board as Figure 15 shows (note that the key must be facing up, away from the board).

Figure 15. 30-Pin IDC Cable Connector

Connect the opposite end of the cable to the EVM or other target device. The red stripe on the cable

indicates pin 1.

Figure 16. 30-Pin IDC Cable Detail

Table 3. 30-pin Cable Pinouts

Schematic Pin Number

Cable Pin Number

Signals Available

J3-8

1

DAC0

J3-7

2

PIO12, CLOCK, EFC0, INT3

J3-6

3

+5VEXT