10

TMP64

SNIS212B – DECEMBER 2019 – REVISED JUNE 2020

www.ti.com

Product Folder Links: TMP64

Submit Documentation Feedback

Copyright © 2019–2020, Texas Instruments Incorporated

8.3 TMP64 R-T table

The TMP64 R-T table must be re-calculated for any change in the bias voltage, bias resistor, or bias current. TI

provides a Thermistor Design Tool to calculate the R-T table. The system designer should always validate the

calculations provided.

8.4 Feature Description

8.4.1 Linear resistance curve

The TMP64 has good linear behavior across the whole temperature range as shown in Figure 1. This range

allows a simpler resistance-to-temperature conversion method that reduces look-up table memory requirements.

The linearization circuitry or midpoint calibration associated with traditional NTCs is not necessary with the

device.

The linear resistance across the entire temperature range allows the device to maintain sensitivity at higher

operating temperatures.

8.4.2 Positive Temperature Coefficient (PTC)

The TMP64 has a positive temperature coefficient. As temperature increases the device resistance increases

leading to a reduction in power consumption of the bias circuit. In comparison, a negative coefficient system

increases power consumption with temperature as the resistance decreases.

The TMP64 benefits from the reduced power consumption of the bias circuit with less self-heating than a typical

NTC system.

8.5 Device Functional Modes

The device has one mode of operation that applies when operated within the Recommended Operating

Conditions.