GAPTEC-Electronic GmbH & Co. KG

sales@gaptec-electronic.com – www.gaptec-electronic.com

Page 4 of 4

6DAMW4_6 – Rev. 2020-1.2

Specifications subject to change without notice.

6DAMW4_6 series

6W - Single Output - 4:1 Ultra Wide Input - Isolated & Regulated

DIP DC-DC Converter

Mechanical dimensions

Recommended footprint

Note:

Unit: mm[inch]

Pin diameter tolerances: ±0.10mm [

General tolerances: ±0.50mm [

Note:

1. The max. capacitive load should be tested within the input voltage range and

under full load conditions;

2. All specifications measured at Ta = 25°C, humidity <75%, nominal input voltage

and rated output load unless otherwise specified.

3. In this datasheet, all the test methods of indications are based on corporate

standards.

4. The performance indexes of the product models listed in this datasheet are

as above, but some indexes of non-standard model products will exceed the

above-mentioned requirements, and please directly contact our technicians for

specific information.

5. Only typical models listed, other models may be different, please contact our

technical person for more details.

6. We can provide product customization service.

7. Products are related to laws and regulations: see "Features" and "EMC".

8. Our products shall be classified according to ISO14001 and related environmen-

tal laws and regulations, and shall be handled by qualified units.