STW5095T datasheet(49/69 Pages) STMICROELECTRONICS

Il numero della parte	STW5095T

Spiegazioni elettronici	Low Power Asynchronous Stereo Audio Codec with Integrated Power Amplifiers

PDF	69 Pages

Scroll/Zoom	100%

Produttore elettronici	STMICROELECTRONICS [STMicroelectronics]

Homepage	http://www.st.com

Logo

49 / 69 page

STw5095

7 Timing Specifications

49/69

Timing Specifications

Unless otherwise specified, VCCIO = 1.71V to 2.7V,Tamb = -30°C to 85°C, max capacitive load

20 pF; typical characteristics are specified at VCCIO = 2.4 V, Tamb = 25 °C; all signals are

referenced to GND, see Note below figure for timing definitions.

Note:

A signal is valid if it is above VIH or below VIL and invalid if it is between VIL and VIH. For the

purpose of this specification the following conditions apply (see Figure 12 above):

a) All input signal are defined as: VIL =0.2•VCCIO, VIH =0.8•VCCIO, tR < 10ns, tF < 10ns.

b) Delay times are measured from the inputs signal valid to the output signal valid.

c) Setup times are measured from the data input valid to the clock input invalid.

d) Hold times are measured from the clock signal valid to the data input invalid.

Note:

All timing specifications subject to change.

Figure 12. A.C. testing input-output waveform

AC Testing: inputs are driven at 0.8

•VCCIO for a logic ‘1’ and 0.2•VCCIO for a logic ‘0’.

Timing measurements are made at 0.7

•VCCIO for a logic ‘1’ and 0.3•VCCIO for a logic ‘0’.

TEST POINTS

0.7

•VCCIO

0.3

•VCCIO

0.7

•VCCIO

0.3

•VCCIO

0.8

•VCCIO

0.2

•VCCIO

INPUT

⁄ OUTPUT

STW5095T Scheda tecnica(PDF) 49 Page - STMicroelectronics