ATXP032 datasheet(90/113 Pages) DIALOG

Il numero della parte	ATXP032

Spiegazioni elettronici	EcoXiP??High Performance Low-Power Octal Flash

PDF	113 Pages

Scroll/Zoom	100%

Produttore elettronici	DIALOG [Dialog Semiconductor]

Homepage	http://www.dialog-semiconductor.com/

Logo

90 / 113 page

ATXP032

DS-ATXP032–114I–4-2020

Figure 13-17. Echo in Octal Mode — SDR

Figure 13-18. Echo in Octal Mode — DDR

13.13 Echo with Inversion (A5)

The Echo with Inversion command is used for testing the signal integrity and delays on I/O lines. It continues to

output data as long as CS is held low and SCK is being clocked. It alternates between transmitting the input data

value it received and the inverse value. It is mostly intended for use in octal mode, but can also be used in the other

modes for generating specific waveforms.

In octal mode, any value sent creates an alternating pulse train. The value entered with the command determines

the value of the first byte returned. The next byte is inverted, and so on. So a value of 00h or FFh causes all the I/O

lines to have the same value and alternate between 00h and FFh, while a value of AAh or 55h alternates between

AAh and 55h.

This command is not supported in SPI mode.

Byte

Output Value

4 Dummy Cycles

Byte

Value

AAh

Opcode

I/O7-0

SCK

Output

Data

Byte Byte

3 Dummy Cycles

1/2 Dummy Cycle

for Octal DTR Alignment

Value

AAh

Opcode

I/O7-0

SCK

DDR

ATXP032 Scheda tecnica(PDF) 90 Page - Dialog Semiconductor