ICS85301 datasheet(10/19 Pages) ICST

10 / 19 page

85301AK

www.icst.com/products/hiperclocks.html

REV. A JANUARY 16, 2006

Integrated

Circuit

Systems, Inc.

ICS85301

2:1

DIFFERENTIAL-TO-LVPECL MULTIPLEXER

TERMINATION FOR 3.3V LVPECL OUTPUT

The clock layout topology shown below is a typical termi-

nation for LVPECL outputs. The two different layouts men-

tioned are recommended only as guidelines.

FOUT and nFOUT are low impedance follower outputs that

generate ECL/LVPECL compatible outputs. Therefore, ter-

minating resistors (DC current path to ground) or current

sources must be used for functionality. These outputs are

designed to drive 50

Ω transmission lines. Matched imped-

FIGURE 3B. LVPECL OUTPUT TERMINATION

FIGURE 3A. LVPECL OUTPUT TERMINATION

ance techniques should be used to maximize operating

frequency and minimize signal distortion. Figures 3A and

3B show two different layouts which are recommended only

as guidelines. Other suitable clock layouts may exist and it

would be recommended that the board designers simulate

to guarantee compatibility across all printed circuit and clock

component process variations.

CC - 2V

RTT

o = 50Ω

FOUT

FIN

RTT =

((V

OH + VOL) / (VCC – 2)) – 2

3.3V

125

o = 50Ω

FOUT

FIN

INPUTS:

PCLK/nPCLK INPUT:

For applications not requiring the use of a differential input,

both the PCLK and nPCLK pins can be left floating. Though

not required, but for additional protection, a 1k

Ω resistor can

be tied from PCLK to ground.

RECOMMENDATIONS FOR UNUSED INPUT PINS

ICS85301 Scheda tecnica(PDF) 10 Page - Integrated Circuit Systems

ICS85301 Scheda tecnica(HTML) 10 Page - Integrated Circuit Systems

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19

Scheda tecnica Scarica

Link URL