AS5047D datasheet(27/40 Pages) AMSCO

27 / 40 page

ams Datasheet

Page 27

[v1-07] 2016-Apr-27

Document Feedback

AS5047D − Application Information

The programming can either be performed in 5V operation

using the internal LDO (1

μF on regulator output pin), or in 3V

operation but using a supply voltage between 3.3V and 3.5V.

Power on cycle

Write the SETTINGS1 and SETTINGS2 registers with the

custom settings for this application (Bit0 of Settings1 is

a factory bit. For programming its mandatory to set this

bit to 0).

Place the magnet at the desired zero position

Read out the measured angle from the ANGLE register

Write ANGLE [5:0] into the ZPOSL register and ANGLE

[13:6] into the ZPOSM register

Read reg(0x0016) to reg(0x0019)

→ Read register step1

Comparison of written content (settings and angle) with

content of read register step1 (Removing of Bit0 of

Settings1 from the comparison is mandatory. Bit0 is

preprogrammed)

If point 7 is correct, enable OTP read / write by setting

PROGEN = 1 in the PROG register

Start the OTP burn procedure by setting PROGOTP = 1

in the PROG register

10. Read the PROG register until it reads 0x0001

(Programming procedure complete)

11. Clear the memory content writing 0x00 in the whole

non-volatile memory

12. Set the PROGVER = 1 to set the guard band for the guard

band test(1).

13. Refresh the non-volatile memory content with the OTP

content by setting OTPREF = 1

14. Read reg(0x0016) to reg(0x0019)

→ Read register step2

15. Comparison of written content (settings and angle) with

content of read register step2.

Mandatory: guard band test (Removing of Bit0 of

Settings1 from the comparison is mandatory. Bit0 is

preprogrammed)

AS5047D Scheda tecnica(PDF) 27 Page - ams AG

AS5047D Scheda tecnica(HTML) 27 Page - ams AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Scheda tecnica Scarica

Link URL