9727 datasheet(6/26 Pages) 3M

Il numero della parte	9727

Spiegazioni elettronici	Scotch-Weld??Hot Melt Applicator PG II LT Owner?셲 Manual

PDF	26 Pages

Scroll/Zoom	100%

Produttore elettronici	3M [3M Electronics]

Homepage	http://www.3m.com

Logo

6 / 26 page

Setup and Installation

3. Install Air Filter and

Regulator

An air filter and moisture trap must be installed at the

applicator connection point of the air system. Install

an air filter WATTS #602-2S Model M4 or equivalent

at the air outlet or as close as possible to it. The hose

connection at the end of the 3M™ Scotch-Weld™

Hot Melt Applicator PG II LT air hose is 1/8’’

standard male pipe fitting.

4. Install Bench Stand

Prior to start up in operation, set the bench stand on

work surface so that tip of the applicator points away

from work area when applicator is not in use. When

bench stand is in most desirable position, fasten

permanently using the screws provided. (If

portability of the bench stand is desired, simply

attach the stand to a piece of scrap wood

approximately 7’’ x 16’’ using either screws or by

adhering the stand to the wood.)

9727 Scheda tecnica(PDF) 6 Page - 3M Electronics