Lilypad USB Plus

DEV-14631 ROHS

This is the LilyPad USB Plus, a sewable electronics microcontroller board controlled by an

ATmega32U4 with the Arduino bootloader. It has a built in power supply JST (and recharge circuit)

and an on/off switch with the only extra piece of hardware you need to program the LilyPad USB

Plus being a micro-USB cable. We’ve also added an RGB LED in the dead-center of the board along

with six white LEDs to act as a sort of bar graph. The LilyPad USB Plus was designed to streamline

your next sewable project by keeping things simple and giving you more room to work while

eliminating the need to sew a power supply.

It has fourteen sew tabs for connecting components with conductive thread. Four of these tabs are

reserved for connecting power and ground of LilyPad sensors and accessory boards, and ten are

input/output (I/O). For reference, each sew tab has a nearby label with its name and the pin number

it is connected to on the ATmega32U4 chip at its center.

LilyPad is a wearable e-textile technology developed by Leah Buechley and cooperatively designed

by Leah and SparkFun. Each LilyPad was creatively designed to have large connecting pads to

allow them to be sewn into clothing. Various input, output, power, and sensor boards are available in

the LilyPad line but will also work with most other wearable e-textile lines. They’re even washable!