SMS47 datasheet(15/19 Pages) SUMMIT

15 / 19 page

2087 1.0 04/11/05

SMS47

SUMMIT MICROELECTRONICS, Inc.

Preliminary Information

Figure 11. Read and Write Operations

I2C PROGRAMMING INFORMATION (CONTINUED)

Writing Configuration Registers

Master

SDA

Slave

Master

SDA

Slave

Reading the Configuration Register

READ OPERATIONS

Read operations are initiated with the R/W bit of the

identification field set to 1. There are two different Read

options: 1. Current Address Byte Read, and 2. Random

Address Byte Read.

Random Address Read

Random address Read operations allow the Master to

access any register location in a random fashion. This

operation involves a two-step process. First, the Master

issues a write command which includes the start condition

and the Slave address field (with the R/W bit set to Write),

followed by the address of the word it is to Read. This

procedure sets the internal address counter of the SMS47

to the desired address. After the word address acknowl-

edge is received by the Master it immediately reissues a

Start condition, followed by another Slave address field

with the R/W bit set to READ. The SMS47 will respond with

an Acknowledge and then transmit the 8 data bits stored at

the addressed location. At this point the Master sets the

SDA line to NACK and generates a Stop condition. The

SMS47 discontinues data transmission and reverts to its

standby power mode.

Figure 12. Write Flow Chart

Operation

a Write?

ACK

Returned

Issue

Address

Proceed

With

Write

Await

Command

Issue Stop

Issue Slave

Address and

R/W = 0

Issue Stop

Write Cycle

In Progress

Yes

Issue Start

Yes

SMS47 Scheda tecnica(PDF) 15 Page - Summit Microelectronics, Inc.

SMS47 Scheda tecnica(HTML) 15 Page - Summit Microelectronics, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19

Scheda tecnica Scarica

Link URL