Data Sheet

ADM3058E

Rev. A | Page 7 of 18

DIN V VDE V 0884-11 (VDE V 0884-11) INSULATION CHARACTERISTICS (PENDING)

These isolators are suitable for reinforced electrical isolation only within the safety limit data. Protective circuits ensure the maintenance

of the safety data.

Table 6. ADM3058E VDE Characteristics

Description

Test Conditions/Comments

Symbol

Characteristic

Unit

Installation Classification per DIN VDE 0110

For Rated Mains Voltage ≤ 150 V rms

I to IV

For Rated Mains Voltage ≤ 300 V rms

I to IV

For Rated Mains Voltage ≤ 600 V rms

I to IV

Climatic Classification

40/125/21

Pollution Degree per DIN VDE 0110, Table

1

2

Maximum Working Insulation Voltage

Reinforced

1500

V peak

Basic, DC Working Voltage

See the Absolute Maximum Ratings section and Table 10

for the maximum continuous working voltage for ac

bipolar, ac unipolar, and dc voltages, basic and

reinforced insulation, and 50-year lifetime to 1% failure

1500

V peak

Input to Output Test Voltage, Method B1

1 sec, partial discharge < 5 pC

2813

V peak

Input to Output Test Voltage, Method A

After Environmental Tests Subgroup 1

partial discharge < 5 pC

2250

V peak

After Input and/or Safety Test

Subgroup 2 and Subgroup 3

partial discharge < 5 pC

1800

V peak

Highest Allowable Overvoltage

8000

V peak

Impulse

1.2 μs rise time, 50 μs, 50% fall time in air to the

preferred sequence

8000

V peak

Surge Isolation Test Voltage

50% fall time

8000

V peak

Safety Limiting Values

Maximum value allowed in the event of a failure (see

Figure 4)

Maximum Junction Temperature

150

°C

Total Power Dissipation at 25°C

1.28

W

Test voltage = 500 V

Ω

0

0.2

0.4

0.6

0.8

1.0

1.2

1.4

0

50

100

150

200

AMBIENT TEMPERATURE (°C)

Figure 4. Thermal Derating Curve, Dependence of Safety Limiting Values

with Ambient Temperature per DIN V VDE V 0884-11 (See the Thermal

Resistance Section for Additional Information)