Interfacing LVDS to LVPECL

An LVDS driver consists of a current source (nominal 3.5mA)

which drives a CMOS differential pair. It needs a differential

resistive load in the range of 70 to 130 ohms to generate

LVDS levels. In a system, the load should be selected to

match transmission line characteristic differential impedance

so that the line is properly terminated. The termination resis-

tor should be placed as close to the receiver inputs as

possible. When interfacing an LVDS driver with a non-LVDS

receiver, one only needs to bias the LVDS signal so that it is

within the common mode range of the receiver. This may be

done by using separate biasing voltage which demands

another power supply. Some receivers have required biasing

voltage available on-chip (V

Figure 5 illustrates interface between an LVDS driver and a

LVPECL with a V

the receiver (Note 15), provide proper resistive load for the

driver and termination for the transmission line, and V

desired bias for the receiver.

Figure 6 illustrates AC coupled interface between an LVDS

driver and LVPECL receiver without a V

resistors R1, R2, R3, and R4, if not present in the receiver

(Note 15), provide a load for the driver, terminate the trans-

mission line, and bias the signal for the receiver.

Note 15: The bias networks shown above for LVPECL drivers and receivers

may or may not be present within the driver device. The LVPECL driver and

receiver specification must be reviewed closely to ensure compatibility be-

tween the driver and receiver terminations and common mode operating

ranges.

Packaging Information

The Leadless Leadframe Package (LLP) is a leadframe

based chip scale package (CSP) that may enhance chip

speed, reduce thermal impedance, and reduce the printed

circuit board area required for mounting. The small size and

very low profile make this package ideal for high density

PCBs used in small-scale electronic applications such as

cellular phones, pagers, and handheld PDAs. The LLP pack-

age is offered in the no Pullback configuration. In the no

Pullback configuration the standard solder pads extend and

terminate at the edge of the package. This feature offers a

visible solder fillet after board mounting.

The LLP has the following advantages:

•

Low thermal resistance

•

Reduced electrical parasitics

•

Improved board space efficiency

•

Reduced package height

•

Reduced package mass

For more details about LLP packaging technology, refer to

applications note AN-1187, "Leadless Leadframe Package"

20157363

FIGURE 5. DC Coupled LVDS to LVPECL Interface

20157364

FIGURE 6. AC Coupled LVDS to LVPECL Interface

www.national.com

9