200218-2600 datasheet(5/8 Pages) MOLEX

5 / 8 page

Hand Crimp Tool for CTX-J 100 Receptacle Terminal

Doc No: ATS-2002182600 Release Date: 03-28-17

UNCONTROLLED COPY

Page 5 of 8

Revision: A

Revision Date: 03-28-17

Locator Replacement

See the parts list on the last page of this document

for the proper locator order number. Follow the steps

below to replace the locator:

1. Open the crimp hand tool.

2. Squeeze gently on the lower area shown in

Figure 7A with your thumb and index finger. The

lower tabs of the locator should disengage from

the hand tool.

3. Lift and pull away from the hand tool. The top

locator hooks should slip out of the top slots

easily. See Figure 7A.

4. To reinstall the new locator, make sure the hand

tool is in the open position.

5. Press the red insert down as far as it will go, as

shown in Figure 7B.

6. Holding onto the lower part of the locator with

your thumb and index finger, insert the locator’s

top hooks (2) into the hand tool top slots.

7. Rotate the locator down, and press the lower tabs

into the two bottom slots of the hand tool. To

secure the locator into place, the lower tabs must

snap into place on the hand tool frame.

Right or Left Hand Operation

This hand tool has an added feature that can be

converted from a right handed application to a left

handed application. It is necessary to reverse the

tooling if using the left handed application along with

the locator. Follow the steps below:

1. The locator must be removed before reversing the tooling.

2. Remove the M3 BHCS, which is holding the upper tooling.

3. Flip the upper tooling to the opposite side and

replace the M3 BHCS. Make sure the small

markings on the front and back of the hand tool

frame match up and are on the outside of the hand

tool frame. See Figures 8 and 9.

4. Do the same thing with the lower tooling, and

tighten the M3 screws. Be sure the small markings

line up.

5. Reinstall the locator by following the instructions in

the locator replacement section.

Figure 8

PUSH ON

HANDLE

JAWS OPEN

PULL OPEN

TOOLING

M3 BHCS

SQUEEZE

HERE

SQUEEZE

HERE

LOCATOR

Figure 7A

TOP HOOKS

TOP SLOTS OF

HANDTOOL

LOWER TABS

MAKE SURE

CENTER OF LOCATOR

IS IN THE

DOWN POSITION

Figure 7B

MATCH

UP MARKS

FRONT

BACK

Figure 8

200218-2600 Scheda tecnica(PDF) 5 Page - Molex Electronics Ltd.

200218-2600 Scheda tecnica(HTML) 5 Page - Molex Electronics Ltd.

Html Pages

1 2 3 4 5 6 7 8

Scheda tecnica Scarica

Link URL