EMDB65xx

Copyright © 2005, EM Microelectronic-Marin SA

9

www.emmicroelectronic.com

12.

HOW TO PROGRAM WITH ELNEC PROGRAMMER

12.1

HOW TO PROGRAM EM6580

It’s only possible to program the EM6580 by the ELNEC programmer in ISP programming mode.

The connector of the ELNEC ISP cable must be connected into the CP2 connector (Pin 1 to Pin 1),

the S6 switch must be placed in PROGRAM position (1), now it’s possible to program the EM6580.

Caution: Jumper JP13 must be present for programming

Remark: Only one EM6580 can be placed on the programming wires in same time.

12.2

HOW TO PROGRAM THE OTHER EM65XX

To program all EM65xx MCU except the EM6580, the user must use the CP3 connector to connect

the ELNEC ISP cable to the MCU. (pin 1 to Pin 1)

No any other manipulation is needed to start to program the device.

Caution: Jumper JP13 must be present for programming

Remark: Only one EM65xx can be placed on the programming wires in same time.

13.

HOW TO PROGRAM WITH EMPB65XX PROGRAMMER

The EMPB65xx programmer is an internal programming solution using to program all EM65xx MCU version

except the EM6580.

It’s possible to program each device type by using the ISP mode through the CP1 connector.

Caution: Jumper JP13 must be present for programming

Remark: Only one EM65xx can be placed on the programming wires at the same time.

14.

SPECIFICATION HISTORY / HISTORIQUE DE LA SPECIFICATION

Rev.

E.C.N.

Pages

Date

Resp.

Description

1.0

15.01.05

Creation

1.1

16.02.05

Add chapter 8,9,10,11,12, 13

2.0

12.09.05

Add chapter 10.1, New version of PCB v2.0