M95640-DF datasheet(29/53 Pages) STMICROELECTRONICS

Il numero della parte	M95640-DF

Spiegazioni elettronici	64-Kbit serial SPI bus EEPROM with high-speed clock

PDF	53 Pages

Scroll/Zoom	100%

Produttore elettronici	STMICROELECTRONICS [STMicroelectronics]

Homepage	http://www.st.com

Logo

29 / 53 page

DocID16877 Rev 19

29/53

M95640-W M95640-R M95640-DF

Instructions

6.9

Read Lock Status (available only in M95640-D devices)

The Read Lock Status instruction (see Table 3) is used to check whether the Identification

Page is locked or not in Read-only mode. The Read Lock Status sequence is defined with

the Chip Select (S) first driven low. The bits of the instruction byte and address bytes are

then shifted in on Serial Data Input (D). Address bit A10 must be 1, all other address bits are

Don't Care. The Lock bit is the LSB (least significant bit) of the byte read on Serial Data

Output (Q). It is at “1” when the lock is active and at “0” when the lock is not active. If Chip

Select (S) continues to be driven low, the same data byte is shifted out. The read cycle is

terminated by driving Chip Select (S) high.

The instruction sequence is shown in Figure 17.

Figure 17. Read Lock Status sequence

M95640-DF Scheda tecnica(PDF) 29 Page - STMicroelectronics