SCG9864 datasheet(6/27 Pages) ETC1

6 / 27 page

SCG9864

8-BIT MICROCONTROLLER

Score Concept Semiconductor Ltd.

Sept 2000

I/O ports

The microcontroller has one 7-bit output port and two software controllable 8-bit I/O ports.

For I/O port 0, there is a pull-low resistor when it is configured as in input mode, and this

resistor is disabled when it is in output mode.

For I/O port 1, it is floating when in input mode.

For Port 2, it is a 7-bit output port only.

Timers

The microcontroller has two programmable 8-bit timers (T0 and T1) for system timing. It has

also a real time timer and a watch dog timer when subsystem clock is employed. All the timers

can be enabled or disabled by configuring an internal register, TCONG. At CPU resets, all of

them are disabled.

T0 and T1 are up-counters and can be configured as either two 8-bit pre-scalar auto reload

timer or as a 16-bit pre-scalar auto reload timer. The timer overflow flag will be set if the timer

overflows. Then an interrupt will be generated if the corresponding interrupt enable bit is set to

The real time timer provides 0.5 sec interrupt for RTC functions. Watch dog timer will overflow

in ~1 sec and then will reset the CPU.

SCG9864 Scheda tecnica(PDF) 6 Page - List of Unclassifed Manufacturers