The information contained herein is exclusive property of Attend. Do not copy and print except that Attend

accepts. 本文件係屬立威科技股份有限公司所有；非經同意，不得以任何覆寫、拷貝、翻印等方式私自據有。亦不得擅加毀損、塗改。

-2 -

Dielectric

withstanding voltage

No breaking insulation

500V AC is applied between an open

contacts for 1 minute.

(Interrupting current : 2mA)

MECHANICAL

Item

Requirement

Test Condition

Card insertion force

10N(1.02kgf) Max

Insert the card at a speed rate of

25+/-3mm/min

Card withdrawal force

0.5N(0.05kgf) Min

Withdraw the card at a speed rate of

25+/-3mm/min

Contact Normal Force

Initial:0.35N Min

After test:0.30N Min

1.15N (REF) max

Apply perpendicular force to terminal at

the rate of 12.5mm/min, measure contact

normal force at 0.27mm working height.

(Test method reference below)

Durability

500 cycles

Mate and unmate connectors to 500

cycles at a maximum rate of 720

cycles/hour.

ENVIRONMENTAL

Item

Requirement

Test Condition

Temperature Life

No breaking

At +85°C For 120 Hours

Thermal Shock

No breaking

-55°C +105°C, 30 Minutes at

each Temperature for 5 cycles

Salt Spray Test

No damage

Salt concentration: 5±1%

Testing time: 48±2 hours

Temperature: 35±2°C

After salt is removed by running water and a

drop is removed, it is measured.

Humidity test

No damage

25~65°C in temperature and 80~95%RH for

96 hours.

After testing connector shall be left

alone for 1~2 hours in a room ambient.

SOLDER ABILITY

Item

Requirement

Test Condition

Solder ability

95% solder coverage

Soldered at temperature 255°C±5°C

For immersion duration “5S”

Resistance to

Soldering reflow Heat

260°C 10Sec