ADS5510 datasheet(6/29 Pages) BURR-BROWN

6 / 29 page

www.ti.com

TIMING CHARACTERISTICS

(1) (2)

ADS5510

SLAS499 – JANUARY 2007

Typical values given at T

A = 25°C, min and max specified over the full recommended operating temperature range, AVDD =

DRV

DD = 3.3 V, sampling rate = 125 MSPS, 50% clock duty cycle, 3-VPP differential clock, and CLOAD = 10 pF, unless

otherwise noted

PARAMETER

DESCRIPTION

MIN

TYP

MAX

UNIT

Switching Specification

Aperture delay

Input CLK falling edge to data sampling point

Aperture jitter (uncertainty)

Uncertainty in sampling instant

300

tSETUP

Data setup time

Data valid(3) to 50% of CLKOUT rising edge

2.3

2.7

50% of CLKOUT rising edge to data becoming

1.7

tHOLD

Data hold time

invalid(3)

Input clock to output data

tSTART

Input clock rising edge to data valid start delay

2.6

valid start (4)(5)

Input clock to output data

tEND

Input clock rising edge to data valid end delay

5.8

6.9

valid end (4)(5)

tJIT

Output clock jitter

Uncertainty in CLKOUT rising edge, peak-to-peak

150

210

psPP

Output clock rise time

Rise time of CLKOUT from 20% to 80% of DRVDD

1.7

1.9

Output clock fall time

Fall time of CLKOUT from 80% to 20% of DRVDD

1.5

1.7

tPDI

Input clock to output clock

Input clock rising edge, zero crossing, to output

4.2

4.8

5.5

delay

clock rising edge 50%

Data rise time

Data rise time measured from 20% to 80% of

3.6

4.6

DRVDD

Data fall time

Data fall time measured from 80% to 20% of

2.8

3.7

DRVDD

Output enable(OE) to data

Time required for outputs to have stable timings

1000

Clock

output delay

with regard to input clock(6) after OE is activated

cycles

Time to valid data after coming out of software

1000

power down

Clock

Wakeup time

cycles

Time to valid data after stopping and restarting the

1000

clock

Clock

Latency

Time for a sample to propagate to the ADC outputs

17.5

cycles

(1)

Timing parameters are ensured by design and characterization, and not tested in production.

(2)

See Table 5 through Table 8 in the Application Information section for timing information at additional sampling frequencies.

(3)

Data valid refers to 2 V for LOGIC HIGH and 0.8 V for LOGIC LOW.

(4)

See the Output Information section for details on using the input clock for data capture.

(5)

These specifications apply when the CLKOUT polarity is set to rising edge (according to Table 2). Add 1/2 clock period for the valid

number for a falling edge CLKOUT polarity.

(6)

Data outputs are available within a clock from assertion of OE; however, it takes 1000 clock cycles to ensure stable timing with respect

to input clock.

Submit Documentation Feedback

ADS5510 Scheda tecnica(PDF) 6 Page - Burr-Brown (TI)

ADS5510 Scheda tecnica(HTML) 6 Page - Burr-Brown (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29

Scheda tecnica Scarica

Link URL