Maximum rating

M48Z512A M48Z512AY M48Z512AV

14/24

3

Maximum rating

Stressing the device above the rating listed in the “Absolute Maximum Ratings” table may

cause permanent damage to the device. These are stress ratings only and operation of the

device at these or any other conditions above those indicated in the Operating sections of

this specification is not implied. Exposure to Absolute Maximum Rating conditions for

extended periods may affect device reliability. Refer also to the STMicroelectronics SURE

Program and other relevant quality documents.

Caution:

Negative undershoots below –0.3V are not allowed on any pin while in the battery back-up

mode. Do NOT wave solder SOIC to avoid damaging SNAPHAT sockets.

Table 6.

Absolute maximum ratings

Symbol

Parameter

Value

Unit

Ambient operating temperature

Grade 1

0 to 70

°C

Grade 6

-40 to 85

–40 to 85

°C

Temperature under bias

Grade 1

0 to 70

°C

Grade 6

–40 to 70

(1)(2)

1.

For DIP package: soldering temperature not to exceed 260°C for 10 seconds (total thermal budget not to

exceed 150°C for longer than 30 seconds). No preheating above 150°C, or direct exposure to IR reflow (or

IR preheat) allowed, to avoid damaging the Lithium battery.

2.

For SO package, Lead-free (Pb-free) lead finish: Reflow at peak temperature of 260°C (total thermal

budget not to exceed 245°C for greater than 30 seconds).

Lead solder temperature for 10 seconds

260

°C

Input or Output voltages

–0.3 to 7

V

Supply voltage

M48Z512A/512AY

–0.3 to 7.0

V

M48Z512AV

–0.3 to 4.6

V

Output current

20

mA

Power dissipation

1

W