CAT25C128VT2 datasheet(10/12 Pages) CATALYST

10 / 12 page

CAT25C128/256

Document No. 1018, Rev. I

SCK

HOLD

tCD

tHD

tCD

tLZ

tHZ

HIGH IMPEDANCE

Note: Dashed Line= mode (1, 1) — ———

Figure 9.

HOLD

HOLD Timing

Figure 10.

WP Timing

tCSH

SCK

tWPS

tWPH

Note: Dashed Line= mode (1, 1) — ———

DESIGN CONSIDERATIONS

If an invalid op code is received, no data will be shifted

into the CAT25C128/256, and the serial output pin (SO)

will remain in a high impedence state until the falling

edge of

CS is detected again.

When powering down, the supply should be taken down

to 0V, so that the CAT25C128/256 will be reset when

power is ramped back up. If this is not possible, then,

following a brown-out episode, the CAT25C128/256

can be reset by refreshing the contents of the Status

The CAT25C128/256 powers up in a write disable state

and in a low power standby mode. A WREN instruction

must be issued to perform any writes to the device after

power up. Also,on power up

CS should be brought low

to enter a ready state and receive an instruction. After

a successful byte/page write or status register write the

CAT25C128/256 goes into a write disable mode.

must be set high after the proper number of clock cycles

to start an internal write cycle. Access to the array during

an internal write cycle is ignored and program-ming

is continued. On power up, SO is in a high impedance.

CAT25C128VT2 Scheda tecnica(PDF) 10 Page - Catalyst Semiconductor

CAT25C128VT2 Scheda tecnica(HTML) 10 Page - Catalyst Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12

Scheda tecnica Scarica

Link URL