INA296A datasheet(20/39 Pages) TI

20 / 39 page

–

IN+

IN–

REF1

REF2

GND

OUT

REF5025

2.5-V

Reference

Figure 8-6. Mid-External Reference Output

8.4.3.4 Output Set Using Resistor Divider

The INA296x-Q1 reference pins allow for the mid-point of the output voltage to be adjusted for system circuitry

connections to analog to digital converters (ADCs) or other amplifiers. The reference pins are designed to

be connected directly to supply, ground, or a low-impedance reference voltage. The reference pins can be

connected together and biased using a resistor divider to achieve a custom output voltage. If the amplifier

is used in this configuration, as shown in Figure 8-7, use the output as a differential signal with respect to

the resistor divider voltage. Use of the amplifier output as a single-ended signal in this configuration is not

recommended because the internal impedance shifts can adversely affect device performance specifications. If

single-ended measurement is required, TI recommends to use an external op amp to buffer the resistor divider

voltage (see Figure 8-8).

IN+

IN±

REF2

REF1

GND

OUT

TO ADC±

TO ADC+

Figure 8-7. Setting the Reference Using a Resistor Divider

INA296A-Q1, INA296B-Q1

SBOSA32A – FEBRUARY 2023 – REVISED AUGUST 2023

www.ti.com

Submit Document Feedback

Product Folder Links: INA296A-Q1 INA296B-Q1

INA296A Scheda tecnica(PDF) 20 Page - Texas Instruments