Pump Calibrator PCE-PWM 10

Pump Calibrator for high-efficiency pumps / PWM and 0 ... 10 testing /

bidirectional testing possible / measurement and generation of test signals

The Pump Calibrator is suitable for testing and setting high-efficiency pumps (HE pumps). The Pump Calibrator can be used both as an

encoder and as a receiver of PWM signals. The Pump Calibrator is thus able to test the pump controller in addition to the HE pump. PWM

signals between 40 ... 2000 Hz can be generated at the output of the Pump Calibrator. The widespread 0 ... 10 V process signal can also be

simulated by the Pump Calibrator. For testing bidirectional HE pumps, PWM signals can be sent and received by the Pump Calibrator at the

same time. In addition, the volume flow or the pump status of the Pump Calibrator is displayed.

The set-points and actual values are visualized on the illuminated LC display. The low weight and compact dimensions ensure that the HE tester

finds its place in every tool case. This makes the Pump Calibrator a safe test device for every installer of heating and ventilation systems. The

Pump Calibrator is supplied with 3 x 1.5 V batteries and is protected according to IP54.

PWM simulation

0 ... 10 V output

Measurement and simulation

Testing of HE pumps

Easy to read display

Display of volume flow or pump status