Low Noise Amplifier

1400 - 2000 MHz

AM50-0006

M/A-COM Inc. and its affiliates reserve the right to make changes to the

product(s) or information contained herein without notice. M/A-COM makes

no warranty, representation or guarantee regarding the suitability of its

products for any particular purpose, nor does M/A-COM assume any liability

whatsoever arising out of the use or application of any product(s) or

information.

• North America Tel: 800.366.2266 / Fax: 978.366.2266

• Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300

• Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298

Visit www.macom.com for additional data sheets and product information.

V3

2

Parameter

Test

Conditions

Units

1500 MHz

1900 MHz

Min.

Typ.

Max.

Min.

Typ.

Max.

Gain

dB

15

18

20

15

17.5

20

Noise Figure

dB

—

1.60

2.00

—

1.65

2.00

Input VSWR

—

Ratio

—

2.2:1

—

—

1.5:1

—

Output VSWR

—

Ratio

—

1.5:1

—

—

1.5:1

—

Output 1 dB Compression

dBm

—

1

—

—

0

—

Input IP3

dBm

—

-5.0

—

—

-6.0

—

Reverse Isolation

—

dB

—

35

—

—

35

—

Drain Current

mA

4.5

6.5

10

4.5

6.5

10

2. Using external 120 ohm resistor. See Functional Schematics.

Parameter

Absolute Maximum

+10 VDC

Input Power

+17 dBm

30 mA

+150°C

Operating Temperature

-40°C to +85°C

Storage Temperature

-65°C to +150°C

3. Exceeding any one or combination of these limits may cause

permanent damage to this device.

4. M/A-COM does not recommend sustained operation near

these survivability limits.

5. When pin #2 is used to increase current (see note 8).

6. Thermal resistance (

θjc) = +150°C/W.

Handling Procedures

Please observe the following precautions to avoid

damage:

Static Sensitivity

Gallium Arsenide Integrated Circuits are sensitive

to electrostatic discharge (ESD) and can be

damaged by static electricity. Proper ESD control

techniques should be used when handling these

devices.

†

Meets JEDEC moisture sensitivity level 1 requirements.

0 2 X Y