Low Cost MMIC Mixer

1400 - 2100 MHz

MAMXSS0013

M/A-COM Inc. and its affiliates reserve the right to make changes to the

product(s) or information contained herein without notice. M/A-COM makes

no warranty, representation or guarantee regarding the suitability of its

products for any particular purpose, nor does M/A-COM assume any liability

whatsoever arising out of the use or application of any product(s) or

information.

• North America Tel: 800.366.2266 / Fax: 978.366.2266

• Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300

• Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298

Visit www.macom.com for additional data sheets and product information.

V2

2

RoHS

Compliant

Electrical Specifications

Parameter

Test Conditions

Units

Min.

Typ.

Max.

Conversion Loss

dB

—

8.0

9.0

Isolation

LO to RF

LO to IF

RF to IF

dB

dB

dB

—

—

—

28

15

15

—

—

—

VSWR

RF Port

IF Port

Ratio

Ratio

Ratio

—

—

—

2.0:1

2.0:1

2.0:1

—

—

—

Input 1 dB Compression

LO = +5 dBm, RF Freq: 1850 MHz

dBm

—

12

—

Two Tones at -10 dBm each, Tone spacing = 100 KHz,

IF = 140 MHz

dBc

—

55

—

4. With external LO Port matching. See functional block diagram.

5. IMR vs. RF drive can be calculated by the formula: IMR = 40-1.5*Pin.

Absolute Maximum Ratings

6,7

6. Exceeding any one or combination of these limits may cause

permanent damage to this device.

7. M/A-COM does not recommend sustained operation near

these survivability limits.

Parameter

Absolute Maximum

RF Input Power

+27 dBm

LO Drive Power

+27 dBm

Operating Temperature

-40°C to +85°C

Storage Temperature

-65°C to +150°C

4x

38.3

27.3

41.3

39.9

45.4

52.5

64.7

77.1

57.0

78.7

3x

21.4

10.5

30.1

30.1

69.0

70.5

43.0

58.8

68.3

76.8

2x

9.0

-0.9

36.1

36.4

36.0

45.8

65.8

75.0

64.3

78.0

1x

1.9

-6.0

0

0

44.8

55.5

56.1

75.2

65.0

78.3

0x

X

X

8.1

8.3

45.5

54.4

56.8

72.3

72.9

74.3

0x

1x

2x

3x

4x

Harmonic of RF

Spurious Table

The spurious table shows the spurious signals resulting from the

mixing of the RF and LO input signals, assuming down

conversion. Mixing products are indicated relative to the IF. The

lower frequency mixing term is shown for two different RF input

levels. The top number is for an RF input power of 0 dBm, the

lower number is for -10 dBm.

RF Frequency = 1850 MHz

LO Frequency = 1710 MHz