EV2364DF-01A – 1.5A, 23V, 1.4MHz DUAL STEP-DOWN CONVERTER EV BOARD

NOTICE:

The information in this document is subject to change without notice. Please contact MPS for current specifications.

Users should warrant and guarantee that third party Intellectual Property rights are not infringed upon when integrating MPS

products into any application. MPS will not assume any legal responsibility for any said applications.

EV2364DF-01A Rev. 1.1

www.MonolithicPower.com

4

3/1/2006

MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.

© 2006 MPS. All Rights Reserved.

TM

QUICK START GUIDE

The output voltages of this board are set to 3.3V (VOUTA) and 2.5V (VOUTB). The board layout

accommodates most commonly used inductors and output capacitors.

1. Attach the positive and negative ends of the first load to the VOUTA and GND pins,

respectively. If using both outputs, attach the positive and negative ends of the second load to

the VOUTB and GND pins, respectively.

2. Preset the power supply output to 4.75V to 23V and turn it off.

3. Connect the positive terminal of the power supply output to the VIN pin and the negative

terminal of the power supply output to the GND pin.

4. Turn the power supply on. The MP2364 will automatically startup.

5. To use the Enable function, apply a digital input to the EN pin. Drive EN higher than 2.5V to turn

on the regulator and less than 0.7V to turn it off.

Calculate the new values by the following formulae:

⎟⎟

⎠

⎞

⎜⎜

⎝

⎛

−

×

=

1

92

.

0

V

6

R

1

R

OUTA

⎟⎟

⎠

⎞

⎜⎜

⎝

⎛

−

×

=

1

92

.

0

V

3

R

4

R

OUTB

Where R6 = 10kΩ and R3 = 10kΩ

Example:

Ω

=

−

×

Ω

=

k

9

.

25

)

1

92

.

0

3

.

3

(

10k

1

R

Therefore, use a 25.5kΩ standard 1% value resistor.