M68HC08 datasheet(91/288 Pages) FREESCALE

91 / 288 page

System Integration Module (SIM)

MC68HC908BD48 — Rev. 2.1

Data Sheet

Freescale Semiconductor

System Integration Module (SIM)

7.3 SIM Bus Clock Control and Generation

The bus clock generator provides system clock signals for the CPU and

peripherals on the MCU. The system clocks are generated from an

incoming clock, OSCOUT, as shown in Figure 7-2.

Figure 7-2. OSC Clock Signals

7.3.1 Bus Timing

In user mode, the internal bus frequency is the oscillator frequency

(OSCXCLK) divided by four.

7.3.2 Clock Start-Up from POR

When the power-on reset module generates a reset, the clocks to the

CPU and peripherals are inactive and held in an inactive phase until after

the 4096 OSCXCLK cycle POR timeout has completed. The RST is

driven low by the SIM during this entire period. The IBUS clocks start

upon completion of the timeout.

7.3.3 Clocks in Stop Mode and Wait Mode

Upon exit from stop mode (by an interrupt, break, or reset), the SIM

allows OSCXCLK to clock the SIM counter. The CPU and peripheral

clocks do not become active until after the stop delay timeout. This

timeout is selectable as 4096 or 32 OSCXCLK cycles. (See 7.7.2 Stop

Mode.)

SIMOSCEN

OSCXCLK

From

SIM

÷ 2

OSCOUT

OSC1

OSC2

÷ 2

BUS CLOCK

GENERATORS

SIM

SIM COUNTER

OSCILLATOR

M68HC08 Scheda tecnica(PDF) 91 Page - Freescale Semiconductor, Inc