PI3USB10M datasheet(2/6 Pages) PERICOM

2 / 6 page

PI3USB10M

4.2V, Wide Bandwidth, 2-Channel,

2:1 Mux/DeMux USB 2.0 Switch with Single Select

PS8799B

03/16/06

DC Electrical Characteristics for USB 2.0 Switching over Operating Range

(TA = –40°C to +85°C, VCC = 3.0 - 4.4V)

Paramenter

Description

Test Conditions(1)

Min.

Typ.(2) Max.

Units

VIH

Input HIGH Voltage

Guaranteed

HIGH level

VCC = 4.2V

2.0

VCC = 3.3V

1.6

VIL

Input LOW Voltage

Guaranteed HIGH level

0.8

VIK

Clamp Diode Voltage

VCC = Max., IIN = –18mA

-0.7

-1.2

IIH

Input HIGH Current

VCC = Max., VIN = VCC

±5

μA

IIL

Input LOW Current

VCC = Max., VIN = GND

±5

RON

Switch On-Resistance(3)

VCC = Min., 1.25V ≤ VIN ≤ VCC,

IIN = –40mA

4.0

6.5

Ω

RFLAT(ON)

On-Resistance Flatness(3)

VCC = Min., VIN @ 1.5V and

VCC IIN = -40mA

1.0

ΔRON

On-Resistance match from cen-

ter ports to any other port(3)

VCC = Min., 1.5V ≤ VIN ≤ VCC,

IIN = -40mA

0.9

2.0

Notes:

1. For max. or min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

VCC = 3.0 - 4.4V, TA = 25°C ambient and maximum loading.

3. Measured by the voltage drop between Y and In pin at indicated current through the Switch-On-Resistance is determined by the lower ofthe

voltages on the two (Y, In) pins.

Storage Temperature ......................................... –65°C to +150°C

Supply Voltage to Ground Potential ....................–0.5V to +4.0V

DC Input Voltage .................................................–0.5V to +5.5V

DC Output Current ........................................................... 120mA

Power Dissipation ................................................................ 0.5W

Note: Stresses greater than those listed under MAXIMUM RAT-

INGS may cause permanent damage to the device. This is a stress

rating only and functional operation of the device at these or any other

conditions above those indicated in the operational sections of this

specification is not implied. Exposure to absolute maximum rating

conditions for extended periods may affect reliability.

Maximum Ratings

(Above which useful life may be impaired. For user guidelines, not tested.)

Power Supply Characteristics (VCC = 3.0 - 4.4V)

Parameters

Description

Test Conditions(1)

Min.

Typ.

Max.

Units

ICC

Quiescent Power Supply Current

VCC = Max., VIN = GND or VCC

800

µA

Notes:

1. For max. or min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

06-0014

PI3USB10M Scheda tecnica(PDF) 2 Page - Pericom Semiconductor Corporation

PI3USB10M Scheda tecnica(HTML) 2 Page - Pericom Semiconductor Corporation

Html Pages

1 2 3 4 5 6

Scheda tecnica Scarica

Link URL